2. Connect the Hoses
CAUTION: Risk of restricted water flow and product damage.
Supply hoses must not be taut, kinked, or twisted during
installation. If the supply hoses must be coiled, maintain an inside
diameter of 3″ (76 mm).
Connect and tighten the supply hoses to the supply stops.
Place a bucket under the copper outlet tube.
Turn on the water supplies.
Flush hot and cold water into a bucket for 1 minute to remove
any debris.
Ø 3"
(76 mm) Min
Supply Hose
Copper
Outlet Tube
1320925-2-C 6 Kohler Co.
To Next Page
Loading...
