Kohler KDI 1903M - Fuel System Assembly

9
ASSEMBLY INFORMATION
EN 128
9.8 Fuel system assembly
Important
•
Replace the high pressure pipes after two
disassemblies.
•
Remove the protective caps from all th
e
c
omponents of the fuel circuit just before
assembly (Par. 2.9.7).
•
W
hen repaired, RSN-A injectors must be
certified by a Stanadyne centre to check
their correct operation - check the type of
e
ngine mounted injectors on the spare
parts list (RSN-A is specified in the
description).
Fig 9.59
9.8.1 Injector
1. Lubricate the gaskets
U, T, S
, and fit them on
the
injector
Z.
Fig 9.60
2. Fit the injector
Z
in the sleeve
V
.
Fig 9.61
3. Assemble parts P, Q, R.
4. Fit the parts so assembled on the injector Z.
Fig 9.62