INFORMATION ABOUT OPTIONAL
COMPONENTS
11
161
EN
5.
Manually tighten the retainer screw ST_15 o
n
the
box F by slightly rotating the shaft K,
centring the hole on it using the ST_15, to lock
the device.
6.
Rotate the crankshaft and clamp it on the TDC
(Ref. P upwards) using the tool ST_34 secured
in place of the starter motor (detail Q).
7.
Position the box F on the surface R of the
crankcase observing the reference bushings.
8.
Secure the box F using the screws E an
d
Lo
ctite 242 inserting the washers U (tightening
torque at 50 Nm).
9.
Remove the retainer screw ST_15 from the box
F.
•
Check that the retainer screw ST_15 is not
present on the box F (Fig. 11.42).
•
Always replace the gasket W after each
assembly.
•
Lubricate the gasket W with oil before
assembling it.
10.
Insert the gasket W in the seat on the flange o
f
the
oil hose D.
11.
Secure the oil intake hose D using the screws
C.
12.
Perform all operations described in Par. 9.4.3 to
assemble the oil sump.
Fig 11.45
To Next Page
Loading...
