Kohler KDI 1903M - Timing System Gear Disassembly; Flange Unit Disassembly

7
INFORMATION FOR DISASSEMBLY
EN 84
7.9 Timing system gear disassembly
1.
Unscrew screws C and remove camshaft gear D.
2.
Remove lock ring A and the shoulder ring B.
3.
Remove the intermediate gear L.
Fig 7.26
4.
Undo the screws F and remove the intermediat
e
ge
ar support G.
Fig 7.27
7.10 Flange unit disassembly
7.10.1 Flywheel
Important
•
Leave the special tool ST_34 for blocking the
flywheel.
1.
Only undo the screw C located upwards.
2.
Insert the tool ST_09 in the seat of the screw C
tightening it all the way.
3.
Undo the remaining screws D.
Danger
•
The flywheel E is very heavy, pay utmost attentio
n
while removing it in order to prevent it from falling,
with serious consequences for the operator.
4.
Remove the flywheel E.
5.
Remove the tool ST_09.
6.
Remove the tool ST_34 shown in Fig. 7.1.
Fig 7.28