Kohler KDI 3404 TM - 6.4 Oil cooler unit and oil filter replacement

6
73
_04
Fig. 6.43
Fig. 6.44
Fig. 6.41
Fig. 6.42
B
B
A
C
E
D
H
N1
F
G
NM
L
P
H
E
A
ED0053030410
INFORMATION FOR REPLACING THE FUNCTIONAL UNITS
6.4 Oil cooler unit and oil lter replacement
6.4.1 Oil Cooler unit disassembly
Important
• Perform the operations described in Par. 5.1 and Par. 5.2.
• Oil Cooler unit E is not repairable.
1 - Release the clamps A.
2 - Remove the hoses B out of the Oil Cooler unit E.
Warning
• Electric/pneumatic screwdrivers are forbidden.
• Use a suitable container to recover any residue oil.
3 - Unscrew cartridge holder cover H by performing three
complete turns and wait 1 minute.
NOTE: this operation allows to oil contained in the support E to
flow into the oil sump in the correct way.
4 - Unscrew cartridge holder cover H and check that the oil
in the lub. oil filter support E has flowed towards the oil
sump.
5 - Remove quick fitting N1.
6 - Undo the screws C and D and remove the Oil Cooler unit
E.
7 - Remove the gaskets F and G from the Oil Cooler unit E.
6.4.2 Oil lter cartridge replacement
1 - Remove gaskets L, M and N from element holder cover
H.
2 - Remove cartridge P from element holder cover H.