11
1128227-A01-D Date: 13/8/2010
L. Drop-In Installation:
protrusions.
Build stud framing as shown in diagrams, ensuring that
the top is level. Whirlpool must be installed level at all
top edges.
Ensure that the stud framing is not interfering with
pump, air blower and whirlpool plumbing.
Whirlpool must be supported both on the rim and on
the supporting feet. Do not allow the whirlpool to be
supported by the rim alone.
Please remember to provide unrestricted access to the
pump to assist with future maintenance. Access panels
should be wide enough to allow access to the motor, air
blower and adjacent plumbing, and should be secured
by screws to prevent unauthorised tampering.
IMPORTANT:
No motor access, no warranty service.
K. Front & Return Section Installation
Ensure that the bath rim is fully supported.
Build the bath support frame as shown.
When the bath is securely positioned, before the unit
is fully built in, install tapware, connect plumbing to
Run water into the bath and check connections for
leaks.
Pour water around the rail support legs and check for
any leaks.
with installation.
Please remember to provide unrestricted access to the
pump to assist with future maintenance. Access panels
should be wide enough to allow access to the motor, air
blower and adjacent plumbing, and should be secured
by screws to prevent unauthorised tampering.
IMPORTANT:
No motor access, no warranty service.
To Next Page
Loading...
