1266554-A02-A 12
4. Place the small rubber seal on the water inlet pipe.
Place the big rubber seal on the discharge pipe.
Insert the pipes into the corresponding pipeline.
3. Mark the reserved space on the rear end of the discharge
and water inlet pipes.
Cut off the excess and use a file to clean up the edges.
5. Connect bidet water supply hose (straight end onto the water supply fitting on
tank frame). Feed hose under the pan connector (discharge pipe) and attach
the MF fitting onto the 90º bend. Attach this end to the pan inlet.
Ensure the pan fixing bolts are tight against the wall, as shown.
Apply grease to the discharge port to ease installation.
Lift the toilet pan up and onto the bolts.
CAUTION: Toilet is heavy, use a two person lift.
Fixing bolt
90º bend
Bidet water
supply hose
M-F fitting
Bidet water supply
Bidet water
supply hose
Kohler Co. March 2016
To Next Page
Loading...
