Need help?Do you have a question about the koino K50 SERIES and is the answer not in the manual?
General| Brand | koino |
|---|---|
| Model | K50 SERIES |
| Category | Controller |
| Language | English |
Indicates serious injury or death may occur if instructions are not observed.
Indicates damage to the instrument or injury may occur if instructions are not observed.
Details supported input types, signal codes, and temperature ranges for sensors.
Explains the various output configurations, including alarm and control outputs.
Describes setting the PID control mode for heating and cooling applications.
Step-by-step guide for installing the K54 series controller onto a panel.
Installation steps for K52, K53, K57, and K59 series controllers.
Illustrates terminal connections for K52 and K53 models.
Shows terminal arrangements and wiring for the K54 model.
Details the terminal layout and wiring for the K57 controller.
Provides terminal arrangements and wiring diagrams for the K59 controller.
Lists default input and output values set at the factory.
Verifies external wiring, specifications, and terminal arrangements.
Confirms default input/output settings and how to change them.
Explains how to set the input and output types for the controller.
Details how to set the target value and initiate auto-tuning.
Covers settings for control zone, fuzzy logic, and ramp functions.
Details how to set and control three different set values (SV1, SV2, SV3).
Guides on performing auto-tuning to optimize PID values.
Steps to set the heater break alarm current.
Configures the dead band (hysteresis) for the heater break alarm.
Sets the starting point for the heater break alarm.
Monitors the AC current flowing through the heater.
Accesses the menu for setting alarm parameters.
Accesses the group for configuring output settings.
Accesses the group for configuring input settings.
Selects the sensor input type from a wide range of options.
To Next Page