DESCALING
A IMPORTANT!
Descaler contains acids which may irritate the skin and eyes. It is vital
to respect the manufacturer's safety warnings given on the descaler
pack and the warnings relating to the procedure to follow in the event
of contact with the skin and eyes.
Proceed as follows:
I . Completely empty the water tank
2. Fill the tank with the descaler solution obtained by diluting the
descaler with water following the instructions on the pack.
3. Pressthe ON/OFF button(fig. 41 )
4. Make sure the filter holder is not attached and position a recipient
under the boiler outlet(fig. 42).
5. Wait for the power lights to come on steadily, indicating that the
appliance is ready for use.
6. Make sure the dial is in the coffee position, Press and hold the
and button 2 seconds at the same time(fig. 43), The button blue
lights will blink to indicate that the appliance has entered the descale
programme, The descale programme starts and the descaler liquid
comes out of the boiler outlet.
The descale programme removes limescale deposits from inside the
appliance by automatically performing a series of rinses and pauses
until the tank is completely empty.
A PLEASE NOTE:
• The device will work for 20 seconds and then pause for 30 seconds
as a cycle, and work continuously for 15 cycles until it stops
• In the descaling mode, you can press the power button to pause the
descaling. To exit the descaling mode, you must unplug the power plug.
7. The coffee maker is now ready for rinsing through with clean water.
Extract the water tank, empty, rinse under running water, fill with fresh
water up to the MAX level and put back in the appliance.
20
To Next Page
Loading...