6
Consumer Service: 1.800.453.7673
www.kolcraft.com
N Start by inserting the two fabric pulls on the seat pad
into the slots located at the seat back support. Then,
insert the other 6 plastic tabs on the seat pad into slots
located around the front of the seat ring. Slide tabs
through holes.
O Underneath the tray, pull tabs and align into grooves.
Test: Push down hard on seating area of seat pad to
make sure seat is securely in place.
CAUTION: Do not use walker if all tabs are not secured
properly, otherwise child may fall through walker.
N
Tabs
O
Tabs
Grooves
2
To Adjust Seat Pad Height
NOTE: As your child begins to grow, adjust height of walker via
the seat pad so that their feet touch the ground when seated. To
determine correct height after assembly, place child in walker
and make sure both feet touch the ground but are not flat
footed. Always make sure seat pad is adjusted to the correct
height position before placing child in product.
1 After seat pad is attached to tray, flip unit upside down to
access the adjustment strap on underside of seat pad.
2 Please note, to ensure proper operation, you will need to
periodically adjust the seat adjustment strap to
accommodate your child’s increased height. For smaller
babies, seat pad should be extended to its lowest
position. To adjust seat height, push button in on
adjustment strap to release restraint.
3 As baby grows, raise seat by tightening strap. This helps
to prevent the child from placing their feet flat on ground
and prevents your child from climbing out.
To Next Page
Loading...
Need help?
General
