50 Disassembly and assembly SEN00462-01
114E-3 Series
3
Coating materials list 1
a The recommended coating materials such as adhesives, gasket sealants, and greases used for disas-
sembly and assembly are listed below.
a For coating materials not listed below, use the equivalent of products shown in this manual.
(Rev. 2007/04)
Cate-
gory
Komatsu
code
Part number Q'ty Container Main features and applications
Adhesive
LT-1A 790-129-9030 150 g Tube
• Used to prevent rubber gaskets, rubber cush-
ions, and cork plugs from coming out.
LT-1B 790-129-9050
20 g
(2 pcs.)
Polyethylene
container
• Used for plastic (except polyethylene,
polypropylene, tetrafluoroethylene and vinyl
chloride), rubber, metal, and non-metal parts
which require immediate and strong adhe-
sion.
LT-2 09940-00030 50 g
Polyethylene
container
• Features: Resistance to heat and chemicals.
• Used to fix and seal bolts and plugs.
LT-3
790-129-9060
(Set of adhesive
and hardener)
Adhesive: 1 kg
Hardener: 500 g
Can
• Used to stick and seal metal, glass, and plas-
tics.
LT-4 790-129-9040 250 g
Polyethylene
container
• Used to seal plugs.
Holtz MH 705 790-129-9120 75 g Tube • Heat-resistant seal used to repair engines.
ThreeBond
1735
790-129-9140 50 g
Polyethylene
container
• Quick-setting adhesive.
• Setting time: Within 5 sec. to 3 min.
• Used mainly to stick metals, rubbers, plastics,
and woods.
Aron-alpha
201
790-129-9130 2 g
Polyethylene
container
• Quick-setting adhesive.
• Quick-setting type.
(max. strength is obtained after 30 minutes)
• Used mainly to stick rubbers, plastics, and
metals.
Loctite
648-50
79A-129-9110 50 cc
Polyethylene
container
• Features: Resistance to heat and chemicals.
• Used for fitted portions used at high tempera-
tures.
Gasket sealant
LG-1 790-129-9010 200 g Tube
• Used to stick or seal gaskets and packings of
power train case, etc.
LG-5 790-129-9080 1 kg
Polyethylene
container
• Used to seal various threaded portions, pipe
joints, and flanges.
• Used to seal tapered plugs, elbows, and nip-
ples of hydraulic piping.
LG-6 790-129-9020 200 g Tube
• Features: Silicon-based heat and cold-resis-
tant sealant.
• Used to seal flange surfaces and threaded
portions.
• Used to seal oil pan, final drive case, etc.
LG-7 790-129-9070 1 kg Tube
• Features: Silicon-based quick-setting sealant.
• Used to seal flywheel housing, intake mani-
fold, oil pan, thermostat housing, etc.
LG-8
ThreeBond
1207B
419-15-18131 100 g Tube
• Features: Silicon-based, heat and cold-resis-
tant, vibration-resistant, impact-resistant seal-
ant.
• Used to seal transfer case, etc.
To Next Page
Loading...
