140-3 SERIES
13-7
DISASSEMBLY AND ASSEMBLY GENERAL DISASSEMBLY OF ENGINE
4. Corrosion resistor, aftercooler, and air intake
pipe
1) Remove tubes (1) and (2) and 5 mounting
bolts of corrosion resistor (3), then remove
corrosion resistor (3) (only when it is
installed).
2) Remove tubes (5) and (6) of aftercooler (4).
3) Remove the 14 mounting bolts of the after-
cooler.
★ The 3 bolts on the head cover side are used
to the fuel high-pressure tube clamp, too.
4) Remove the mounting bolts of air intake
pipe (7) and turbocharger lubricating oil tube
(8), then lift off aftercooler (4).
5) Pull out air intake pipe (7).
5. Tension pulley assembly
1) Loosen tension pulley mounting nut (1).
2) Loosen adjustment bolt (2) and move the
tension pulley inward, then remove fan belt
(3).
3) Remove mounting bolt (4) and tension pul-
ley assembly (5).
6. Fan pulley assembly
Remove the mounting bolt and the fan pulley
assembly.
To Next Page
Loading...
