140-3 SERIES
13-55
DISASSEMBLY AND ASSEMBLY PROCEDURE FOR REMOVING AND INSTALLING FUEL SUPPLY PUMP
10.
Turn bolt
O2
clockwise to pull out the fuel supply
pump drive gear. Take care not to drop the key
(19).
11.
Remove the bolts and nuts loosened in 9 above,
then remove the fuel supply pump.
12. Procedure for installing fuel supply pump
Install the fuel supply pump by performing the
removal procedure in the reverse order.
★ Tightening torque
3
:
1) Fuel supply pump drive gear mounting nut:
176.5 – 196.1 Nm {18 – 20 kgm}
2) Fuel supply pump tube
Supply pump side:
39.2 – 49.0 Nm {4 – 5 kgm}
Common rail side:
49.0 – 58.8 Nm {5 – 6 kgm}
3) Clamp
,
: 9.8 ± 1.0 Nm {1.0 ± 0.1 kgm} (M6)
To Next Page
Loading...
