Komunica HF-PRO-2 - User Manual

P o r t able M ul t i- B and HF
An t enna H F - P RO - 2
Specifications
F re qu e n c y range
7 - 30 + 50 M H z
M ax . P o wer R a t i ng
130 W ( SS B )
I m p e d a n c e
50 Ω
L e ng th
2,6 m
Wei gh t
425g r
C onn e c t o r
P L - 259
Type
Loaded 1/4 wave vertical on 7-30MHz
Full 1/4 wave vertical on 50Mhz.
A ntenna elements
Supplied are :
A L ar g e W h i p = P W R - 01002 (used for 7 - 30 M H z )
A Short Whip = PWR-01003 (used for 50MHz )
C o il form c o m po si t i on
FR P ( F i b er R ei n f o r c e d P o ly m er)
Notes fo r Using the Antenna
To use your HF-PRO-2® from Komunica® antenna correctly, please read these instructions thoroughly before use and keep this
document on-hand for later reference.
The HF-PRO-2® from Komunica® is intended for use by Radio Amateurs only within their authorised frequency bands. For use on
some amateur bands an antenna tuning unit may be required.
Please note:
1. The HF-PRO-2® has been designed as a stationary antenna and is not designed for use on a moving vehicle.
2. You are recommended to only install the antenna on your vehicle with a mount that is earthed or on a magnetic base once you
have parked your vehicle.
3. The HF-PRO-2® should not be permanently installed as a home station antenna as it is not designed to withstand rain and winds.
4. Do not touch the antenna during transmission. Doing so can cause an electric shock and/or an RF burn.
5. When mounting or detaching the antenna, take care not to cause personal injury with the whip.
6. To get the best performance from the HF-PRO-2® use of an Antenna Coupler (ATU) is recommended .
Desc r iption
1.The HF-PRO-2® can be operated on a wide frequency range of 7-30 and 50MHz. This antenna is to be used for “Static mobile” or
portable operation, never when you are mobile as mechanically the antenna has not been designed for use on moving vehicles. It
is the owner’s responsibility to use this antenna only in an appropriate and responsible manner.
2.The operational frequency is easily adjusted by moving the loading coil up or down as required and by using an antenna tuning
unit if one is connected.
3.When operating on 50MHz, please ensure that the short top element (PWR01003) is installed above the lower element
(PWR01001) and that the coil is slid down to its lowest point (i.e. fully retracted).
4.Thanks to the fiber reinforced polymer (FRP) material with which Komunica® has manufactured its HF-PRO-2®, the antenna is
both lightweight & flexible and is small when packed away making it easy to carry when not in use.

Komunica HF-PRO-2 Specifications