Konica Minolta CL-70F - Selecting the Exposure Time (Ambient Modes Only)

24
4. Setting the Measuring Conditions
4-1-2 Selecting the Exposure Time (Ambient Modes Only)
Set a posure Time for ambient measurement.
Operation
1.
T ouch the [Exposure Time] indication on the Measurement screen.
Touch the [Auto], [0.1 sec] or [1.0 sec] button.
2.
Touch the [OK] button.
Conrms the settings, and returns to the previous Measurement screen.
Touch Cancel to return to the previous measurement screen without setting.
Exposure time is set.
NOTE
In uto mode, the CL-70F automatically selects among  measuring times,
determined by the illumination available, to achieve a proper result in a convenient way.
Two ed reading times are available to enable eact comparison of multiple
measurements.
When measuring high illuminance levels, set the posure Time to 0. sec.
When taing measurements in low Illuminance, set the posure time for .0 sec.
NOTICE
.1 sec and 1. sec may not cover some measurement range of illumination
and [OVER] or [UNDER] appears. In this case, set Exposure time to "Auto".
Measuring Screen Exposure Time Screen
[Cancel]
Button
[OK]
Button
The selected
button will
be displayed
encircled in
blue.