Konica Minolta CL-70F - Page 52


4. Setting the Measuring Conditions
4.
Press the Measuring Button 5 to measure.
The Light Selection Ring
2
should be set to L  )
when taing ambient light measurements.
When measuring ash units, select Range L  )
or Range   ) depending on the brightness of
the ash. 
¨
77,
¨
7)
Measurements can now be made.
NOTE
Measurement and display will tae longer in light levels below 0l. The LC
illumination will normally switch off during measurement to avoid inuence to
measurement.
5.
The current measurement is displayed at the top of display area.
6.
Touch the [Memory Selection] icon.
The [Spectrum Comp. Memory] screen will be displayed.
Light Selection Ring
2
Measuring Button
5
Memory
Selection] Icon
Spectrum Comp.
Memory Screen
Spectrum Comp.
Screen
Memory
Selection
Area
Current
Measurement