Konica Minolta CL-70F - Page 57

44
4. Setting the Measuring Conditions
4.
Press the Measuring Button 5 to measure.
The Light Selection Ring
2
should be set to L  )
when taing ambient light measurements.
When measuring ash units, select Range L  )
or Range   ) depending on the brightness of
the ash. 
¨
77,
¨
7)
Measurements can now be made.
NOTE
●
raph display areas Ra, R  R are always displayed.
●
Measurement and display will tae longer in light levels below 0l. The
LC illumination will normally switch off during measurement to avoid
inuence to measurement.
●
Ra is the avaraged value from R to R only. R to R are not included in
the Ra.
5.
Touch the [Display Item] indication to change.
The Display item library screen will be displayed.
6.
Touch the desired Display Item.
Select the item to display above the graph.
Indication will be encircled in blue.
Light Selection Ring
2
Measuring Button
5
isplay Item
Indication
Display Item LibraryCRI Screen