1.3 Safety precautions
19
Chapter 1
CAUTION
– When placing the DR Detector under the patient
as part of the exposure process, insert and pull
out the detector slowly.
– Use the recommended adapter when you need
to perform exposure on a stretcher or a place
where load is to be applied locally.
– Exposing or immersing the DR Detector to patient
body uids, chemicals, water, etc. may allow such
liquids to enter through exterior gaps and cause a
failure. Make sure to cover the DR Detector with
a vinyl sheet, etc.
– Be careful of the ingress of patient body fluids,
chemicals, water, etc., because the AeroDR
1417HQ, AeroDR 1417S, AeroDR 1717HQ, and
AeroDR 1012HQ are not designed to be water-
proof.
– The AeroDR 2 1417HQ, AeroDR 2 1417S,
AeroDR 3 1417HD, AeroDR 3 1717HD and
AeroDR 3 1012HQ are designed to have water-
proof capabilities, but be careful when handling
them because they are not guaranteed to be
completely waterproof. Also, be careful because
subjecting them to strong impacts or excessive
loads by dropping or hitting them against other
objects may diminish their waterproof capabilities.
– Never leave DR Detectors in hot and humid envi-
ronments for long periods of time.
– The DR Detector has wireless antennae posi-
tioned at 2 places. Do not block them with the
body or metal because that will interfere with, dis-
connect or slow down wireless communication.
– Pressing the power switch on the AeroDR
1417HQ, AeroDR 1417S, AeroDR 1717HQ,
AeroDR 1012HQ, AeroDR 2 1417HQ and Aero-
DR 2 1417S causes each LED (green, orange,
blue) to light temporarily or ash. After this, only
green begins to flash in a slow cycle. Please
check the lighting or ashing of each color once.
CAUTION
– Pressing the Power SW of the AeroDR 3
1417HD, AeroDR 3 1717HD and AeroDR 3
1012HQ causes the Information LED (white) to
flash or light. After this, the Battery LED (blue)
lights. Please check the flashing or lighting of
each color.
– The battery capacity is designed to allow the life
period calculated based on the standard usage
of the DR Detector. It can be replaced with a
new battery for a fee if replacement is necessary
after the warranty period due to battery break-
down or decrease in capacity.
– Check that the buzzer sounds when inserted in
the AeroDR Battery Charger or AeroDR Battery
Charger2.
– Check that the LED indicates recharging status
when the AeroDR 1417HQ, AeroDR 1417S,
AeroDR 1717HQ, or AeroDR 2 1417HQ is in-
serted in the AeroDR Battery Charger.
– Check that the LED indicates recharging status
when inserted in the AeroDR Battery Charger2.
– Be careful not to get your hand caught when in-
serting the DR Detector into the AeroDR Battery
Charger or AeroDR Battery Charger2.
– If the DR Detector is inserted into the AeroDR
Battery Charger or AeroDR Battery Charger2,
make sure that the AeroDR Battery Charger or
AeroDR Battery Charger2 will not tip over due to
any shock applied to the DR Detector.
To Next Page
Loading...
Need help?
General
