16
3
Open the slide cover and press the [SET] key.
The instrument is now ready for you to enter a value,
and one of the following values will appear.
z
If no reference value had been set, “00.00” will
appear (with the decimal point blinking).
z
If the reference value had already been set, it will appear
(with the decimal point, “0” or “00” blinking).
z
If an integer value (i.e. a value which does not have a decimal point) has
been set as the reference value, the
three decimal points will blink.
4
Select the effective digits of the reference value using the [
▲
]
and [
▼
] keys.
z
The display will change as follows each time the key is pressed.
* In the above example, the [
▲
] key is pressed to change the display. The display will
change in opposite direction if the [
▼
] key is pressed.
* Values in ( ) indicate the settable range.
↓
↓
↓
↓
（0.01〜29.99）
（0.1〜299.9）
（1〜2,999）
（10〜29,990）
（100〜299,900）
→
To Next Page
Loading...
