Konica Minolta T-10A - Measuring Integrated Illuminance; Integrated Illuminance Measurement Steps

17
5
Press the [
►
/D-OUT] key to select the digit to be changed.
The value at the selected digit will blink.
6
Change the value using the [
▲
] and [
▼
] keys.
7
Repeat steps 5 and 6 to complete entry of the desired
reference value.
z
To cancel entry of the reference value, press the [CALL] key.
8
If the entered reference value is satisfactory, press the [SET]
key.

The reference value will be set, and “±0 lx” or “100.0 %” will appear.
z
To check the entered reference value, press the [CALL] key. The reference value will be displayed
while the [CALL] key is held down.