Konica Minolta T-10A - Print Example

37
2
Set the instrument’s power switch to “I” (ON), then turn ON
the printer.
3
Push out the hold button (RUN), and start measurement.
4
Press the [
►
/D-OUT] key.

Each time the key is pressed, the data effective when the key
is pressed will be sent to the printer and printed out.
z
If you want to hold the data, push in the hold button
(HOLD), then press the [►/D-OUT] key.
z
While the printer cable T-A12 is connected to the instrument, consumption current will be approximately
1.5 times as much as when it is disconnected.
z
If you are not going to use the printer, make sure that the printer cable is disconnected.
Print example
NORM: Displays illuminance (lx).
⊿ : Displays illuminance difference (lx).
⊿ : Displays illuminance ratio (%).
Σ : Displays integrated illuminance (lx·h).
Σ : Displays integration time (h).
(The print contents are the same as when integrated illuminance is measured.)
Σ : Displays average illuminance (lx).