USAGE NOTES / FUNCTION
HEIGHT ADJUSTMENT
ADJUSTMENT STEPS
- turn the piano bench around and
- place the cushion on a flat surface.
- hold one leg
- Settings - see Ill. 1-4
- repeat this with the
- second leg
CHECK, MAINTENANCE, CLEANING
- In the event of workstation maintenance pay attention to possible risks.
- To care for the product use a damp cloth and a non-abrasive cleaning agent.
FAULT FINDING (F) and SOLUTION (S)
F: The piano bench is not stable B: Tighten the screws and check the surface i.e. ensure that the bench is on a level surface.
F: The piano bench is leaning to one side B: Make sure that the leg adjustments are at the same height (same markings).
DIMENSIONS
Loosen the clamp
screws a bit
Pull the handle until
the locking bolt is
no longer in the drill
hole
Pull out or
push in the
extension
arm
Place the lock
pin/bolt in the
desired position
(hole) and tighten
the clamp handle
The drill holes are marked
on each leg; this makes it
much easier to adjust the
height to the same
level.
The STOP label
indicates that the
maximum height
has been reached.
The bench height
can now be adjusted
- choosing from 25
possible adjustment
increments - each
10 mm.
TECHNICAL DATA / SPECIFICATIONS
Material
Base: Tubes, struts, screws, discs - Steel powdered / galvanized / nickel plated, black
Plastic Parts - PA, TPE, black
Bench: 14085 -imitation leather, 14086-fabric covering, black
Dimensions External: W x D - 660 x 375 mm; Bench: 660 x 330 mm; Height: min. 430mm / max .670 mm
Weight net: 8.5 kg
Packaging Single Box: L x W x H - 675 x 400 x 130 mm
To Previous Page
Loading...
Need help?
General
