Need help?Do you have a question about the Konig Easy-fit Series and is the answer not in the manual?
General| Brand | Konig |
|---|---|
| Model | Easy-fit Series |
| Category | Automobile Accessories |
| Language | English |
Fit nylon bumpers to prevent scratches on alloy wheels.
Extend the rigid arch and release any locking mechanisms before fitting.
Fit chain from top, place arch behind wheel, and verify correct placement.
Open pedal, push it down until click to tighten, then check final position.
Do not remove chain before moving vehicle; handle pedal release with care.
Use the correct dismounting position and deactivate the safety device.
Press release buttons to loosen chain; pull grips to raise pedal.
Move vehicle slowly forward to facilitate chain removal.
Verify tyre/chain fit, observe 50 km/h limit, replace chains if wear exceeds 45%.
Clean chains with water, dry in sun, and note the 5-year warranty.
To Next Page
