Why is my Könner & Söhnen KS 7HP-950A Tiller engine overheating?
If your Könner & Söhnen Tiller engine is overheating, consider these possible reasons: * The distance between the spark plug electrodes might be incorrect. Set the correct distance between them. * The air filter might be dirty. Clean the air filter. * The cooling ribs might be dirty. Clean the cooling ribs. * The engine oil level might be too low. Add engine oil.
Why is there increased vibration when working with my Könner & Söhnen KS 7HP-950A?
Increased vibration when working with the Könner & Söhnen Tiller can be caused by weakened engine mounts. Tighten the engine screws to resolve this issue.
What to do if there is no draft when pressed on clutch lever in Könner & Söhnen KS 7HP-950A Tiller?
If there is no draft when pressed on the clutch lever of your Könner & Söhnen Tiller, it might be due to an improperly installed clutch cable. Adjust the clutch rope to correct this.
What to do if my Könner & Söhnen Tiller has decreased engine power?
If you're experiencing hard starts or decreased engine power with your Könner & Söhnen Tiller, begin by cleaning the fuel tank. A dirty air filter can also contribute to these issues, so clean the air filter as well. Additionally, if the spark plug is sooted, clean the cooling ribs. Finally, if there's water in the fuel tank or the carburetor is occluded, empty the fuel tank and clean both the fuel line and the carburetor.
Why Könner & Söhnen Tiller has increased vibration when working?
Increased vibration when working with the Könner & Söhnen Tiller can often be attributed to weakened engine mounts. To resolve this, simply tighten the engine screws.
What to do if Könner & Söhnen KS 7HP-950A Tiller has no draft when pressed on clutch lever?
If there is no draft when pressed on the clutch lever of your Könner & Söhnen Tiller, it might be due to an improperly installed clutch cable. Adjust the clutch rope to correct this issue.
General| Engine Type | 4-stroke |
|---|---|
| Engine Power | 7 HP |
| Engine Displacement | 212 cc |
| Fuel Tank Capacity | 3.6 L |
| Oil Tank Volume | 0.6 L |
| Type of Start | Manual |
| Number of Cutters | 4 |
| Tilling Depth | 30 cm |
| Gears | 2 forward / 1 reverse |
| Transmission | Chain |
To Next Page
