CONTENTS
PET PAW™
1. To remove battery compartment cover, pinch
rear clasp to release.
2. Insert one 9-V battery. Reattach compartment
cover.
3. If your Pet Paw will not activate your Pet Chime,
use a small screwdriver to fine tune the sensi-
tivity by turning within 1mm clockwise or count-
er-clockwise while pressing the Paw repeatedly
until you hear that the Pet Chime is activated.
Pet Paw™
• Easy battery replacement
• Operates on one 9V battery
(not included)
Pet Chime™
• Wireless chime operates up to 100 ft.
from the Pet Paw™
• Wall mountable or stand on shelf.
• Operates on three AA batteries
(not included)
The PET CHIME™ consists of the following 2 units:
INSTALLATION AND OPERATION INSTRUCTIONS
insert screwdriver here
PET CHIME™
1. To open the battery compartment cover,
press the dots, then push and slide
upwards.
2. Insert three AA batteries, following the
+ and – diagram in the cavity for cor-
rect placement.
3. Select a chime: D = Regular (Ding
Dong) or B3 = (Woof-Woof)
4. Reattach compartment cover.
To Previous Page
Loading...
