17
• ALWAYS TURN THE POWER OFF AT THE POWER
OUTLET BEFORE YOU INSERT OR REMOVE THE
POWER PLUG. REMOVE BY GRASPING THE PLUG
• DO NOT PULL ON THE CORD
• THIS APPLIANCE IS INTENDED FOR INDOOR USE
ONLY.
• DO NOT PLACE NEAR ANY HOT SURFACE.
• DO NOT PLACE ON OR NEAR A HOT GAS FLAME,
ELECTRIC ELEMENT, HEATED OVEN OR ANY HOT
SURFACE.
RISK OF ELECTRICAL SHOK!
• THIS APPLIANCE IS DESIGNED TO OPERATE ONLY
WITH ALTERNATING CURRENT. BEFORE OPERATING,
MAKE SURE THAT THE VOLTAGE CORRESPONDS TO
THE ONE INDICATED ON THE DATA PLATE.
• ONLY CONNECT THE APPLIANCE TO THE POWER
OUTLETS WITH A MINIMUM CAPACITY OF 10 AM-
PERES.
• DO NOT PULL THE POWER CORD OR THE AP17
PLIANCE ITSELF TO REMOVE THE PLUG FROM THE
WALL SOCKET.
• FULLY UNWIND THE POWER CORD BEFORE OPE-
RATING THE APPLIANCE.
• USE AN ELECTRIC EXTENSION CORD ONLY IF IT
IS IN PERFECT CONDITION.
• NEVER LET THE POWER CORD RUN THROUGH
SHARP EDGES; AVOID CRUSHING IT.
• DO NOT LEAVE THE APPLIANCE EXPOSED TO
ATMOSPHERIC AGENTS (RAIN, FROST, SUN, ETC.).
• NEVER USE THE APPLIANCE:
To Next Page
Loading...