Connect the charger's electric cable to an electrical outlet Open the cover to the charging port in
your scooter (note: be sure to keep any liquids away from charging port and cable), and then
connect the charging cable to the scooter's charging port under the footboard, on the right side at
the front. Always plug the charger into the wall first before the device. The charger o^ers a
charging status on the top of the charger:
Charging Light Red Battery is charging.
Charging Light Green Charging is complete.
Once the charger is plugged into the wall and then the charging port, the charging light should
turn red, indicating that it is charging. If it does not turn red, either the battery is full or the charger
is not properly connected to the Beam. Once the light has turned green and charging is complete,
unplug the cable from the charging port, as overcharging your scooter can affect the ser-vice life
of the batteries.
(Please note: Always plug the charger into the wall first before the device. If the wall outlet doesn't
have power and you plug the charger into the unit, it will light green, even if the battery is not full.
So always plug into the wall first to make sure there is power.)
Average charge time is 3 hours. Charge the battery only using tools approved for the E1.
To maximize your scooter's battery performance, fully charge it for 3 hours, once a month, or after
each use of twelve hours. It is dangerous to use the E1 when plugged into an AC outlet. Electrical
shock can cause seri-ous injury and damage the scooter. Do not attempt to open the battery. Do
not insert anything in the battery and do not attempt to open its case with any tool.Inserting an
object into openings or in the battery can cause electrical shock, injury, burns or fire. Any attempt
to open the battery case will damage it and cause release of dangerous toxic substances. Unplug
the E1 from the outlet before performing any maintenance. Carry the E1 accord-ing to all
applicable local and national requirements.
PROTECTION AGAINST OVER-DISCHARGING
The E1 has a built-in smart over-discharging protection system that will actively cut o
幵
the power
when the scooter is in a locked or shutdown state and battery power is too low. Once the scooter
goes into the over-discharging protection mode, it needs to be awakened by charging. If the
scooter remains un-awakened after 30 minutes of charging, please contact the authorized dealer
of the E1, or koowheel's customer service.
！ safety warning
● Risk of fire.
● No User Serviceable Parts.
● Use only the specified charger.
● When not riding, stored in the house, to avoid exposure to UV and water
To Next Page
Loading...