To Next Page
J
jaclynpowellAug 6, 2025
What to do if the KOP & WDHOM KP-MIG200D shows abnormal indicator lights?
- Mmichael14Aug 6, 2025
If the indicator lights on your KOP & WDHOM Welding System are abnormal while the meter shows a reading and the fan is working, it could be due to over-current protection. Turn off the power switch and restart the machine after the abnormal indicator light has winked. Alternatively, it might be overheating protection. In this case, wait for about 2-3 minutes for the machine to recover without turning off the power switch.
General