koramzi CD55 - CD Player Operation; Disc Loading and Playback; Track Selection and Programming

4
CD OPERATION
Discs for Playback
This system can playback all digital audio CD, finalized digital audio CD-Recordable (CD-R)
discs, finalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital audio
CD/CD-R/CD-RW discs.
LOADING A DISC
1. Press the SOURCE button on unit to select “CD” mode.
2. Open CD door, “OP” will be shown on the display.
3. Place an audio CD DISC into the tray with the front side facing up.
4. Close the CD door, the display will show a flashing “CD - - -”, then the playback will start
from the first track.
5. To remove the CD, press /CH- button to turn off the unit, and then open the CD
compartment lid. Hold the CD by its edges, and take it out carefully.
Note:
1. Make sure the disc is stopped before opening the CD DOOR.
2. To ensure good system performance; wait until the unit completely reads the disc before
proceeding.
3. If no disc loaded into the tray, or the disc is unreadable, the display will show “no”.
PLAYING A DISC
1. The playback starts from track 1, Press the /CH+ button to pause playback, the “ ”
indicator and the current track will flash on the display.
To resume playback, press the /CH+ button again.
1. To stop playback, press the /CH- button, the total number of tracks appears on the
display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the or button on unit on stop mode or during playing until the desired track
appears on the display. It will start play automatically.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the or button on unit to scan the current playing track at high speed until
desired point (passage) appears, then release the button for normal playback mode. Playback
will start again from this point.
PROGRAMING TRACKS
Programming tracks of disc are possible when playback is stopped. Up to 20 tracks for CD disc
can be stored in the memory in any order.
1． In stop mode, press the PORG/MEM. button on unit enter program setting, the
display will flash show PROG and P01.
2． Press the / button on unit to select the first desired track to be programmed.
(example: track 2)
3． Press the PORG/ MEM button on unit to enter. The display would flash PROG and show
P02.
4． Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5． Press the /CH+ button on unit to start playback from the first programmed track.
6． Press the /CH- button on unit to stop program playback.