MIDI > Control Change
58
Control Change
When you operate the damper pedal, adjust the balance in
Layer mode, or make other adjustments on the control panel,
a Control Change message is sent to a connected external
MIDI device. At the same time, C-540 can receive a Control
Change message from an external MIDI device connected to
its MIDI IN, to control the damper pedal, volume adjustment,
and other data.
Control Change enable/disable
The C-540 usually receives Control Change data. If you don’t
want to receive (or transmit) them, use the Filter function. See
“MIDI Filters” on page 53.
C540_Book.fm Page 58 Friday, September 14, 2007 12:12 PM
To Next Page
Loading...
