Korg DSS-1 - Page 123

■ About the Auto Level Adjust capability.
This provides smoother connection between the two
linked waveforms by automatically finding the first
point in the second waveform that has the same level
as the end of the first waveform.
Here there is a point ai me same level as
the end of the first waveform.
Auto level adjust is carried out.
If no point can be found at the same
level...
Then auto level adjust is not
possible.
■ About the Link Cross Fade capability.
This provides a gradual change between the two link
ed sounds.
Note:
A link cross fade can not be carried out if the cross ;
fade length is 000000. So, no cross fade is possible :
if there is no remaining space in the work area :
(wave memory).
The cross fade length is set in multiples of 256 {256, j
51 2t 768, etc.), therefore, a link cross fade is not j
possible if either the first sound (A) or the second j
sound (B) or the remaining area is shorter than 256. .
Link point.
Remaining area
If link is redone, this is reinstated.
123
EDIT SAMPLE MODE