2/ Move the cursor to the parameter value that you
want to change.
NCJ
res
Use to select
Parameter
■3) Use DATA EN TR Y A and B to adjust the value.
OAT A ENTRY A
DATA EN TR Y B
LU
Use to adjust
value
You can select the parameter by moving the cursor.
h 4 .:::=UUhD !::■ I !-!h. I /LfciNb
S .. S H H i - l i - Ib n s . 1 0 0 0 I V 'I
■ Use the C O M P A R E key to make comparisons bet
ween the effects of newly assigned and previous set
tings.
i) Pressing the C O M P A R E key once recalls the setting
that existed previously (that which appeared im
mediately upon selecting the Sound Start & Length
function).
C O M P A R E
Press
You can adjust the value after moving the cursor,
h" id -.! i\ ikM ! ! _ . ! ! /! K L-=
S s «a-1 S ..." S S IE \ l ’ V— Li • 11 ►
h 4 a
■ ■■■ ■ ■ ■ H I a | + m * i) ii) * a a - - - « t r I I * «
4
l-hb M b I « a a r i l l !
S r S , L t - I M k i Ì M
Ab ■ * * bba l a a M a a s p M l H M a J H H I M l M b M a gg q q g g a
Recalls the setting that existed previously.
F4 SOUND STRRT/UENG
S = 5 0 0 0 0 0 0 b . L 0 0 0 I2 1
ii) Press the C O M PAR E key again to bring back the new
setting.
COMPARE
Press
Brings back the new setting.
F4 SOUND START/LENG
S. S 0 0 0 0 0 0 5. L00010T
★ Repeating the above two steps (that is, repeatedly
pressing the C O M PAR E key) lets you compare the ef
fects of the new setting with the previous setting.
To Next Page
Loading...
