Korg DW-6000 - D;A Converter Voltage Check; DWGS Clock Check; OSC1 VCA Level Check

6
Tape
Interface
^.
VERIFY
Procedure
The VERIFY
procedure
should always
be used immediately after
you
finish a
SAVE
operation. This
is
to
make
sure that data has been properly recorded. It is also useful
for
determining
the best playback level setting
for
your
recorder.
H
Connect the DW-6000 rear panel FROM TAPE
jack to
the output jack (earphone, line
out, etc.) of your
recorder. Set the LOW/HIGH
switch to match your tape
recorder's output signal level.
rFROMTAPE"
LOW
HIGH
ir
Recorder output jack