Grandstage X
-
MIDI settings
92
Universal system exclusive messages (real-time)
- Master Volume
[F0, 7F, 0g, 04, 01, vv, mm, F7]
(3rd byte g: Global Channel, vv: lower value, mm: upper value, 16,384 steps for both combined)
If you set “Master Volume” for the foot pedal function in system settings, this message is transmitted
when you operate the pedal, which changes the output volume at the final stage. When this message
is received, an effect similar to operating the pedal on the Grandstage X is applied.
- Master Fine Tuning
[F0, 7F, nn, 04, 03, vv, mm, F7]
(set to center when the value is 8192 [mm, vv=40, 00], -50 when the value is 4096 [mm, vv=20, 00],
and +50 cents when the value is 12288 [mm, vv =60, 00]).
When this message is received, “Tune(Master Tune)” in system settings is set.
3rd byte nn: Channel
= 0 - F: Global Channel
= 7F: Any Channel
- Master Coarse Tuning
[F0, 7F, nn, 04, 04, vv, mm, F7]
(Normally, only the upper value mm is used. This is set to center when the value is 8192 [mm, vv=40,
00], -12 semitones when the value is 6656 [mm, vv=34, 00], and +12 semitones when the value is
9728 [mm, vv=4C, 00]).
When this message is received, Transpose is set.
3rd byte nn: Channel
= 0 - F: Global Channel
= 7F: Any Channel
To Next Page
Loading...
