177
18. EFFECTS
Liverpool is equipped with four powerful Effect Pro-
cessors (A, B, C, D). You can send them the internal
tracks.
DIAGRAMS
The following instructions show the signal path dia-
gram for each of the effect types. The signal coming
from the tracks (Send) is mono. Before entering an
effect processor, it is split in two “wires” (Left and
Right), and processed in stereo. The signal is then out-
put in stereo from the effect processor, and sent to the
Mix output (Left&Right, the heaphones or the internal
speakers).
DYNAMIC MODULATION SOURCES
When the symbol is encoutered, a Dynamic Mod-
ulation can be applied to the corresponding parameter.
The following table shows the available modulation
sources.
Filter and dynamics control effects
000: No Effect
Select this option when you do not use any effects.
When this option is selected, the effect is muted.
001: Amp Simulat
(Stereo Amp Simulation)
This effect simulates the frequency response character-
istics of guitar amplifiers. It is also effective for organ
and drum sounds.
Modulation source Note
Off No modulation
Gate1
Gate1+Dmpr
Gate2
Gate2+Dmpr
Note Nr Note Number
Velocity Note Velocity
ATouch After Touch
JS X Joystick Left/Right
JS+Y: CC#01 Joystick Forward
JS-Y: CC#02 Joystick Backward
MIDI(CC#04)
MIDI(CC#12)
MIDI(CC#13)
MIDI(CC#16)
MIDI(CC#18)
MIDI(CC#17)
Send
Right
Left
Effect Block
Diagram
MIDI(CC#19)
MIDI(CC#20)
MIDI(CC#21)
Damper: #64
Prta.SW: #65 Portamento Switch
Sostenu: #66 Sostenuto Pedal
MIDI(CC#80)
MIDI(CC#81)
MIDI(CC#82)
MIDI(CC#83)
Te m po
FILTER/DYNAMIC
a
Amplifier Type
Selects the type of guitar amplifier
SS, EL84, 6L6
b
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
–100...+100
Modulation source Note
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Amp Simulation Filter
Amp Simulation Filter
To Next Page
Loading...
