Korg Nu:Tekt OD-S - Assembly Parts List

- 6 -
1
5
6
7
8
17
18
9
19
21
22
20
10
11
12
13
14
15
16
14
2
3
4
1 Upper case Aluminum 1
2 Lower case Aluminum 1
3 Case screws Flat head screw, M3 x 12 4
4 Rubber feet Polyurethane 12.7 x 3.6 4
5 Volume knobs Includes set screws 4
6 Volume nuts M7, wide 10mm 4
7 Volume washers 7.2 x 12 4
8 LED holder -- 1
9
Washer Included with LED holder 1
Nut Included with LED holder 1
10 Nutube bottom cushion Sponge 48 x 22 x 7 1
11 Battery (sold separately) 9V alkaline battery (6LF22/6LR61) --
12 Battery cushion Sponge 90 x 54 x 2 1
13 Foot switch unit LED 1
14 Nut M12, wide 14mm 2
15 Internal tooth lock washer 12.8 x 16 x 0.5 1
16 Washer 12.3 x 16 x 0.5 1
17 Jack nut Wide 11mm 2
18 Jack washer 10 x 15 x 0.3 2
19 Nutube circuit board unit -- 1
20 Main circuit board -- 1
21
Harness A
Harnesses (8) 1
22
Circuit board cushion
Sponge 45 x 14 x 4 1
23 Rating label
-- 1
Tip: Affix the rating label onto the bottom of the case or similar location.
Note: The following parts are included but not used in assembly.
-
Parts included with phone jack: Plastic washers (2), fiber washers (2)
Assembly Parts List