Korg SDD-3000 PEDAL - Program and Delay Time Controls; Program Management Features; Delay Time Setting Methods

9
4. PROGRAM
1. PROGRAM display
This display shows the bank
number (01–40) and chan-
nel of the program that’s
currently selected on the
SDD-3000 PEDAL. There are
two channels (A and B) for each
bank.
2. WRITE button
Press this buon to write (save)
a program.
3. EXIT button
Press this buon to cancel the
operation that’s currently being
performed.
5. DELAY TIME
1. TIME/VALUE display
This display shows the delay
time and the value of the
various parameters.
2. DELAY TIME knob
Use this knob to set the delay
time (1–4000 msec) or set as a
note when SYNC is on.
3. R TIME button
When on (LED lights up),
the delay time for the right
channel can be controlled with
the DELAY TIME knob. In
addition, the feedback for the
right channel can be adjusted
with the FEEDBACK knob.
After the delay time and
feedback controlled by the
knobs are switched from
the left channel to the right
channel or from the right
channel to the left channel,
the values will not change,
even if the knobs are
adjusted, until the knobs
are set to match the current
parameter setting.
When SYNC is on, the delay
time for the le or right
channel will be set as a note
synchronized to the tap tempo.
See page 18 “Seing the delay
time as a note”.
1. PROGRAM display
2. WRITE button
3. EXIT button
4. FINE button
3. R TIME button
2. DELAY TIME knob
5. SYNC LED
1. TIME/VALUE
display
4. FINE button
When on (LED lights up),
the delay time can be nely
adjusted within a range of –50
msec and +50 msec.