Korg ZERO4 - Normal Mode and LINE Input Test

Normal Mode Check
Preparation
*For example,
Turn the power on of D3200. Select the DemoSong"I'd Be A Fool".
this explanation uses the D3200.
P
ressing the SONG switch of the D3200, and press the "+ "or" -" for several times,
Any sound source is Ok which
w
hen
"I'd Be A Fool"
is displayed then release your fingers from the switches.
can be connected to the ZERO4.
Set the MASTER FADER of the D3200 to "0".
C
onnect the ZERO4 and the D3200 like following.
ZERO4
CH1 LINE L/MONO ― D3200 MASTER OUT L
ZERO4
CH1 LINE R ― D3200 MASTER OUT R
Check
・
C
onfirm that the setting of ZERO4 is factory setting.
・
T
urn the power on of the ZERO4.
C
onfirm that the display is "120.0".
Confirm that the TAP LED under the "120.0" is blinking.
S
et the ZERO4 like following.
BOOTH VOL, MASTER VOL->MAX (right end)
CH1
,2,3,4 MODULE FADER->MAX (top)
M
ONITOR BAL , LEVEL (right bottom side)->MAX (right end)
CH
1,2,3,4 INPUT SELECTOR->LINE
MONITOR
・
Confirmation of LINE
(
TRS
)
INPUT
.
P
ress the PLAY switch of D3200. (Demosong starts.)
Connect the headphones to the standard jack of ZERO4 MONITOR. (front left side)
Y
ou can hear the demo song of the D3200, confirm that there is not noise
and fragmentary sound.
S
et the LEVEL (right bottom side) to MIN (left end).
C
onfirm that the sound disappeared.
T
ake out the headphone plug from the standard jack and connect to the mini jack.
S
et the LEVEL (right bottom side) to MAX (right end).
Y
ou can hear the demo song of the D3200, confirm that there is not noise
and fragmentary sound.
S
et the LEVEL (right bottom side) to MIN (left end).
C
onfirm that the sound disappeared.
S
et the LEVEL (right bottom side) to MAX (right end).
T
ake out the headphone plug from the mini jack and connect to the standard jack.
*
Before CH4 the demo song
T
ake out the cable which is connected to the
CH1 LINE L/MONO
of ZERO4,
of the D3200 finished,
t
hen connect it to the CH2 LINE RL/MONO
P
ressing the STOP of D3200
P
ress the REW switch.
T
ake out the cable which is connected to the
CH1 LINE
R of ZERO4,
T
he song returns to the top.
t
hen connect it to the CH2 LINE R.
T
hen press the PLAY.
Y
ou can hear the demo song of the D3200 from CH2, confirm that there is not noise
and fragmentary sound.
S
ame as above confirm the sound (D3200 demo song) from the headphones
regarding CH3,CH4.
A
fter confirmation of the CH4,
P
ress the STOP switch of the D3200. Then the demo song stops.
P
ressing the STOP of the D3200, press the REW. (the song returns to the top.)
P
ull out the cables which are connected.
KORG INC.
ZERO4 (X-5800) Check before Shipping
Revised
No.
Date 5／102007/4/23
QCI-5800 Page