Installation Instructions
4. Attach the device bracket to the K-Bar using
smaller size screw.
5. Slide the fixed device bracket onto the wall
bracket.
Connecting the K-Bar
Always switch OFF the power on each device before connecting it to your K-Bar
Connect the power cord to the K-Bar and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
• There are no operator serviceable parts inside the unit.
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
• Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
• To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which
located on the bottom of the unit.
To Next Page
