Kramer KDS-SW2-EN7 - Quick Start Guide Manual

KDS-SW2-EN7 Quick Start
P/N:
2900- 3015 4 7 QS
Rev:
1
Scan for full manual
KDS-SW2-EN7 Quick Start Guide
This guide helps you install and use your KDS-SW2-EN7 for the first time.
Go to www.kramerav.com/downloads/KDS-SW2-EN7 to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check what’s in the box
KDS-SW2-EN7 2x1 4K AVoIP Switcher Encoder
2 Bracket sets
1 Quick start guide
Step 2: Get to know your KDS-SW2-EN7
#
Feature
Function
1
HDMI IN Connector
Connect to an HDMI acceptor.
2
USB-C IN Port
Connect to a USB-C source.
• When powered by a Kramer 24V power supply (optional), charges sources (that
support USB Power Delivery 2.0) up to 60W.
3
LCD Display
Use for device configuration such as input selection, unique channel/AV stream setting
and EDID.
4
Menu Navigation
Button

Press to return to the previous menu.

Press to move up to the next configuration parameter.

Press to go to the next menu.

Press to move down to the next configuration parameter.
Enter
Press to accept changes.
5
LINK LED
See LED Functionality.
6
NET LED
See LED Functionality.
7
ON LED
See LED Functionality.
#
Feature
Function
8
24V/5A DC Connector
Connect to the power adapter (purchased separately).
9
RESET Recessed Button
Press and hold for 10 seconds to reset the device to its factory default values. All LEDs flash.
10
LAN MEDIA 1G(PoE) RJ-45
Port
Unicast: connect for streaming either directly to a decoder or via LAN.
Multicast: connect to multiple decoders or connect to one decoder to which multiple
decoders are daisy-chained via SERVICE (1G) port.