6.2.1 Acquiring the EDID from a Selected Output
To select an EDID from a selected output, do the following:
1. Press the SELECT button, as required, to reach the desired output, which
flashes.
2. Press the READ button.
The EDID of the selected output is stored in the non-volatile memory when
the READ button no longer illuminates as well as the selected output LED.
6.2.2 Restoring the Default EDID
To restore the default EDID, do the following:
1. Press the SELECT button several times until the OUTPUT LEDs flash
simultaneously.
2. Press the READ button.
The READ button illuminates.
The default EDID is stored in the non-volatile memory when the READ
button no longer illuminates as well as the output LEDs.
To Next Page
Loading...