Kramer VM-2Hxl Quick Start Guide

Step 4: Connect power
Connect the power cord to VM-2Hxl and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
• There are no operator serviceable parts inside the unit.
Warning:
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
Step 5: Operate the VM-2Hxl
Acquire the EDID from a connected output:
1. Press and hold the EDID SETUP button to select the desired EDID.
2. The OUT LEDs illuminate in the following cycle: OUT 1, OUT 2, both illuminate (auto-mix) and both flash (default).
3. Release the button when reaching the desired set up. (If you set the machine to acquire the EDID from an output that
is not connected, the default EDID is acquired)
4. The EDID is now acquired.

Kramer VM-2Hxl Specifications

General

Brand	Kramer
Model	VM-2Hxl
Category	Media Converter
Language	English