Install VM-50AN using one of the following methods:
• Attach the rubber feet and place the unit on a flat surface.
• Mount the unit in a rack using the recommended rack adapter (see www.kramerav.com/product/VM-50AN).
• Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of the circuits.
• Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-50AN.
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-50AN.
Using third-party cables may cause damage!
Step 5: Connect power
Connect the 12V DC power adapter to VM-50AN and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
• There are no operator serviceable parts inside the unit.
Warning:
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate VM-50AN
Set the input mode to balanced or unbalanced stereo.
Using a small screwdriver, adjust the output level.
To Previous Page
Loading...
Need help?
General
