Kramer WP-789R User Manual

WP-789R Quick Start
P/N:
2900- 301299QS
Rev:
1
Scan for full manual
WP-789R Quick Start Guide
This guide helps you install and use your WP-789R for the first time.
Go to www.kramerav.com/downloads/WP-789R to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
WP-789R HDMI 4K Wall-Plate Line Receiver
1 Quick start guide
Installation accessories
1 Power adapter and cord
Frame (or frame kit)
Step 2: Get to know your WP-789R
#
Feature
Function
1
HDMI™ OUT Connector
Connect to an HDMI acceptor.
2
IR (Tx1, Tx2) Output, 3-pin
Terminal Block Connectors
Connect to an external IR emitter cable:
Tx1, G: use for fixed 38kHz non-modulated IR signals.
Tx2, G: use for 20-100kHz wide-range modulated IR signals.
3
STATUS LED
LED Color
HDBT Connected
Source Detected
Acceptor Detected
Blue
Yes
Yes
Yes
Green
Yes
Yes
No
Yellow
Yes
No
N/A
White
Device is powered with no detected connections.
STATUS LED is off only when the device does not receive power.
4
RS-232 (G, Rx, Tx)
3-pin Terminal Block Connector
Connect to an RS-232 port.
5
Power Supply 2-pin Terminal
Block Connector
Connect to a power supply (if required). Connect GND to GND, +12V to +12V.
6
Ring Tongue Terminal
Grounding Screw
Connect to grounding wire (optional).
7
HDBT IN RJ-45 Connector
Connect to the HDBT OUT connector on a transmitter (for example, TP-780T).
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Kramer WP-789R Specifications

General

Brand	Kramer
Model	WP-789R
Category	Media Converter
Language	English