To Next PageTo Next PageWhat to do if the hose (20) does not retract on Kraus Kitchen & Bath Fixtures?
If the hose (20) on your Kraus Kitchen & Bath Fixtures isn't retracting, the weight (22) might not be correctly installed. Try readjusting the weight (22) on the hose (20).
Why is there leaking between the spray head (1B) and hose (20) in Kraus Kitchen & Bath Fixtures?
If there's a leak between the spray head (1B) and hose (20) of your Kraus Kitchen & Bath Fixtures, the spray head (1B) might be loose, or the washer may not be seated correctly in the hose (20). Try tightening the spray head (1B) by hand until it's snug. Also, ensure the washer is seated correctly.
Why is there low pressure for both hot & cold water in my Kraus Kitchen & Bath Fixtures?
If you're experiencing low water pressure for both hot and cold water with your Kraus Kitchen & Bath Fixtures, the EZ-Connect (21) might be clogged with debris. To resolve this, remove the EZ-Connect (21) from the supply hose (19) and spray hose (20). Then, soak the quick connect in a 50/50 solution of vinegar and warm water for 5 to 10 minutes.
How to fix leakage under the handle of Kraus Kitchen & Bath Fixtures?
If you notice leakage under the handle of your Kraus Kitchen & Bath Fixtures, it's likely that the locking nut (8) has come loose. To fix this, remove the cap (4), loosen the set screw (5) with a hex wrench, remove the handle (6), and unscrew the cartridge cover (7) by hand. Finally, tighten the locking nut (8) with an adjustable wrench.
What to do if water will not shut off completely in Kraus Kitchen & Bath Fixtures?
If water won't shut off completely in your Kraus Kitchen & Bath Fixtures, the cartridge (9) may be defective. You can address this by removing the cap (4), loosening the set screw (5) with a hex wrench, removing the handle (6), and unscrewing the cartridge cover (7) by hand. Then, unscrew the locking nut (8) with an adjustable wrench and remove the ceramic disc cartridge (9) to check for cracks.
General| Material | Brass |
|---|---|
| Spout Reach | 8.5 inches |
| Flow Rate | 1.8 GPM |
| Installation Type | Single Hole |
| Spray Function | Yes |
| Number of Holes Required | 1 |
| Overall Height | 15.5 inches |
| Handle Style | Lever |
| Finish | Matte Black |
| Mounting | Deck Mount |
| Spray Head Function | Pull Down |
| Warranty | Lifetime |
| Type | Pull-Down Kitchen Faucet |
