CONNECTIONS
HOW TO CONNECT AT&T CABLES:
a. Remove the plastic cover from the outside of the AT&T
transmitter (located on Transport) and receiver (located on Pro-
cessor).
b. Locate the slot on the top of the AT&T receptacle.
c. Locate the key on the top of the AT&T cable.
d. Remove the plastic cap from both ends of the AT&T cable.
e. Slide the cable connector into the AT&T receptacle with the key
sliding into the designated slot.
f. Gently push the connector into place, depressing the internal
spring, and twist the outer collar clockwise to secure the connec-
tion.
g. Use the same procedure for the transport and D/A Processor
PAGE 18
To Next Page
Loading...