Krone 1022623 - Page 118

14 Terminal machine functions
14.3 Displays on the working screen
118
Comprima F 155
Original Operating Instructions 150001049_01_en
Icon Explanation
2
Direction display arrows:
Arrows appear during operation on the left and right sides of the direction
display. The arrows have three different sizes, numbered from 1to3.
The arrows show the driver to which side and to what extent he must cor-
rect his direction when driving over the swath in order to ensure the bale
chamber is filled evenly.
If the direction of travel is not corrected, the arrow displayed starts flashing
and an acoustic signal sounds.
Detailed information on the direction display, refer to page120
100
50
0
60
%
40/
Set and display the baling pressure.
The baling pressure can be set directly on the working screen, refer to
page122.
TIM function "Opening and closing tailgate at the end of the tying cycle"
has been activated. The TIM function can be switched off individually via
the checkbox, e.g. if the machine is in an unfavourable position for ejecting
the round bale. To configure the TIM software, refer to page145
Round baler
1
2
3
4
EQG003-122
The round baler in the centre of the working screen shows
• the progress of the baling process by means of the expanding round bale(3),
• the progress of the tying process by means of the net roll(1) and by means of the red net
running around the round bale,
• the positions of the feed rotor floor(4)
• and the bale ejection by means of the opening tailgate(2).
The feed rotor floor(4) can show the following positions:
The feed rotor floor is in the top position.
The feed rotor floor is in the bottom position. Crop blockages
can be removed, refer to page92.