Terminal machine functions 14
Operating TIM 1.0 (Tractor Implement Management) 14.9
Comprima F 155
Original Operating Instructions 150001049_01_en 125
Icon Explanation
Start TIM functions (can be selected only when tailgate
closed)
Pause TIM functions. In doing so, registration and authen-
tication are not disconnected between tractor and ma-
chine.
14.9.3 Activating TIM functions
If the machine was switched off and is switched on again, registration and authentication
between tractor and machine are automatically restored. The same control unit is used for the
TIM function "Opening and closing tailgate at the end of the tying cycle" which was used the last
time the machine was commissioned.
To activate the TIM functions, only the connection between machine and tractor must be
established.
ü In menu 14-5 "Configuring TIM software"(refer to page145)
• the required TIM functions were selected and
• registration and authentication were run on the tractor.
ü The TIM status on the working screen is on
.
Press
.
Confirm the TIM functions on the terminal or on another control panel on the tractor.
Æ The TIM status switches to
. The machine automatically takes over control of the
TIM functions on the tractor.
If no TIM status is displayed on the working screen, the TIM functions must be selected and
registered and authenticated via menu 14-5 "Configuring TIM software", refer to page145.
INFORMATION
In the case of the TIM function "Stop tractor when the tying cycle starts", the tractor must be
driven at a speed of at least 0.5km/h before the TIM function can be confirmed on the tractor.
INFORMATION
If 2TIM functions are active and one of them is overridden, the TIM status flashes.
If only one TIM function is active and is overridden, the TIM status switches to
To restore the connection, press the key
.
14.9.4 Pausing TIM functions
If TIM is not to be used for the time being, TIM can be paused. In doing so, registration and
authentication are retained between tractor and machine.
To Next Page
Loading...
