III - 10
Operation
3.7.8 Blockages on the cutter unit
• Lower the cutter unit using the switch on the control
panel and remove the blockage by switching on the
power take-off shaft.
• In addition the scraper floor feed should be switched on
for a short time to reduce the load on the conveyor unit.
• If there is a blockage in the intake area, slightly raise
the articulated tow-bar and lift the pick-up to full extent.
This enlarges the intake area of the conveyor channel
and the blockage can then be more easily removed by
switching on the power take-off shaft.
3.7.7 Retracting the cutter unit
The cutter unit is locked hydraulically by retracting it
against the end stop. To do this
• retract the cutter unit (to the end stop)
• switch the electric switch to „Neutral“
KDW0003
1
2
3
To Next Page
Loading...