VIII - 1
Recommissioning
8 Recommissioning
8.1 Special safety instructions
• The following are fundamentals which apply during all maintenance, assembly, repair and
adjustment work:
• Shut down the machine, switch off the engine, remove the ignition key and switch off the
electrical supply at the control box.
• Secure the tractor and feeder wagon from rolling away.
• Avoid getting oils, greases, cleaning agents and solvents on your skin.
• In case of injury or burns due to oils, cleaning agents or solvents, immediately call a doctor.
• After care and maintenance work is finished, re-install all protective covers and protective
devices in the correct manner.
• All other safety instructions must also be followed to avoid injury and accidents.
8.2 General information
– Lubricate all lubrication points with grease and oil the chains. Wipe away any grease emerging from the
lubrication points.
– Check the oil level in the main transmission box and top up if necessary (delivery rotor).
– Check hydraulic hoses and pipework for leaks and replace if necessary.
– Check the air pressure in the tyres and top up if necessary.
– Check that all screws and bolts are tight and retighten if necessary.
– Check all electrical connection cables and the lighting system and repair or replace as necessary.
– Check the whole superstructure of the feeder wagon.
– Check all adjustments on the feeder wagon and correct if necessary.
To Next Page
Loading...